Clear Coat For Maple Wood

Most floors require two to three coats of polyurethane for adequate protection.

Clear coat for maple wood.

Always apply a second coat and you may want to repeat the process with a third coat. A good finish whether a clear coat or a stain gives you a chance to lock out moisture and remove the risk of rot mold or mildew. Then remove all the sanding dust and apply a second coat. These oils tend to bring out the curly or tiger looks of the maple.

Even when you seal the maple and apply a stain the color may be more uneven than you d prefer and there s an easy way to remedy that. Related products options. Oil based polyurethane is an excellent product to use for this purpose. Fruitwood snw stain on hard maple wood.

Our natural no stain is a clear coat that allows all the natural color grain and character of the wood to show through. Natural clear coat no stain on soft maple wood. Apply a coat of finish and then tone the wood by spraying pigment on the dried finish or wiping on a gel stain. Use this guide to learn more about choosing and using polyurethane the toughest of the clear coatings.

Another commonly used finishing technique on maple is to apply tung oil or linseed oil after the final sanding. When applying polyurethane finish allow the first coat to dry overnight then sand it lightly with 220 grit sandpaper. Most projects will be ready for normal use in 24 hours. Applying a clear finish to wood brings out the wood s natural beauty while sealing and protecting the wood s surface.

Allow each coat to dry for 20 40 minutes at 1 3 mils wet film thickness per coat. Open the can of clear coat and use a stir stick to mix it up. For added durability a third coat can be applied. Most clear finishes are applied with a brush working in the direction of the grain of the wood.

Be sure not to shake the can since it could form bubbles and ruin how the clear coat applies to your piece of maple. The 3 coats will melt into one another and will form a hard clear shell within 24. Fine sand the 2nd coat with 400 grit to remove surface defect and apply one more coat. Follow the oil with a coat or two of shellac.

Coating wood cabinetry furniture or trim with a clear finish whether you stain it or not gives it richness and depth while protecting it from knocks scrapes and the weather. Stir the polyurethane clear coat with a stir stick. If desired these two options can be combined for a mix of beauty and durability. After it dries sand lightly.

Start by sanding the surface thoroughly and wiping it down to remove any dust. For a more durable finish top coat over the shellac with a clear lacquer or polyurethane.